Customization: | Available |
---|---|
Phase: | Single |
Output Power: | 500W to 8000W |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
pure sine wave solar inverter | LW 1000 | LW 1500 | LW 2000 | LW 3000 | LW 4000 | LW 5000 | LW 6000 | |
General Specification | Input Wave form | Sine wave (Utility or Generator) | ||||||
Nominal voltage | 120VAC | 230VAC | ||||||
Low voltage trip | 90v + 4% | 184v/154v + 4% | ||||||
Low voltage reconnect | 100v + 4% | 194v/164v + 4% | ||||||
High voltage trip | 140v + 4% | 253v + 4% | ||||||
High voltage reconnect | 135v + 4% | 243v + 4% | ||||||
Max input AC voltage | 150VAC | 270VAC | ||||||
Nominal input frequency | 50Hz or 60Hz (Auto detect) | |||||||
Low freq trip | 47Hz for 50Hz, 57Hz for 60Hz | |||||||
High freq trip | 55Hz for 50Hz, 65Hz for 60Hz | |||||||
Output wave form | (Bypass mode) same as input | |||||||
Overload protection | Circuit breaker | |||||||
Short circuit protection | Circuit breaker | |||||||
Transfer switch rating | 30amp or 40amp | |||||||
Efficiency on line transfer time | 95%+ | |||||||
Line transfer time | 10ms Typical | |||||||
Bypass without battery connected | yes | |||||||
Max bypass current | 30amp or 40amp | |||||||
Bypass overload current | 35amp or 45amp: Alarm | |||||||
Inverter Specification Output | Output wave form | Pure sine wave | ||||||
Output continuous power watts | 1000 | 1500 | 2000 | 3000 | 4000 | 5000 | 6000 | |
Output continuous power VA | 1000 | 1500 | 2000 | 3000 | 4000 | 5000 | 6000 | |
Power factor | 0.9-1.0 | |||||||
Nominal output voltage rms | 120/230VAC | |||||||
Output voltage regulation | 10% rms | |||||||
Output frequency | 50Hz + 0.3Hz or 60Hz + 0.3Hz | |||||||
Nominal efficiency | > 88% | |||||||
Surge ratings | 3000 | 4500 | 6000 | 9000 | 12000 | 15000 | 18000 | |
Short circuit protection | Yes, fault after 10 seconds | |||||||
Inverter Specification Input | Nominal input voltage | 12V | 24V | 48V | ||||
Minimum start voltage | 10V | 20V | 40V | |||||
Low battery alarm | 10.5V | 21V | 42V | |||||
Low battery trip | 10V | 20V | 40V | |||||
High voltage alram | 16V | 32V | 64V | |||||
Power saver | Below 25watts when enabled | |||||||
Power saver | Same switched on/off on remote | |||||||
Charge Mode Specification | Input voltage range | 95-127VAC | 194-243VAC/ 164-243VAC(W) | |||||
Output voltage range | Dependent on battery type | |||||||
Charge current | 35A/70A | |||||||
Battery initial voltage for start up | 0-15.7v for 12v (*2 for 24v; *4 for 48v) | |||||||
Over charge protection shutdown | 15.7v for 12v (*2 for 24v; *4 for 48v) | |||||||
Others | Remote control/RS232/USB | Yes, Optional | ||||||
Size: in mm | 1000/2000/3000 Model: 442*218*179 | |||||||
4000/5000/6000 Model: 598*218*179 | ||||||||
Net weight | LW1000 | LW1500 | LW2000 | LW3000 | LW4000 | LW5000 | LW6000 | |
18kgs | 19kgs | 20kgs | 22kgs | 35gs | 38kgs | 40kgs |